1.5 Fitting of the heat meter front bracket (optional) The front bracket of the heat meter (HM) is fixed to the inside casing feed-through. To attach this to the right or left outside of the transfer station, if needed, please follow the steps below. 24 1 a b Step 1: Detach the front bracket (a) of the HM from the inside of the casing. After loosening the second wing screw, you can now remove the mounting plate (b) with HM. 2 c d Step 2: Remove the casing of the HM (c) by gently sliding it off the HM moulded part (d). 3 b Step 3: Then loosen the fixing screws and dismantle the moulded part from the mounting plate (b) as shown. 4 a d b Step 4: Attach the HM moulded part (d) to the front bracket (a) and then slide the mounting plate (b) onto it. Please make sure that the drill holes of both brackets are on top of each other. 5 a b Step 5: Now attach the HM front bracket (a) with the mounting plate (b) to the outside of the transfer station. Screw them together with the corresponding wing screws. 6 d c Step 6: Push the casing of the HM (c) onto the moulded part provided (d). Quick reference guide | Standardised heat transfer station
RkJQdWJsaXNoZXIy NzYyNjE=